This is an old revision of the document!
Table of Contents
target_display
This target will display information about the matched packets.
Mode normal
In this mode, informations about packet headers will be displayed. Here are the parameters of this target :
- skip
Number of headers to skip in the packet. For example, if you don't want to see the informations about the ethernet layer, set skip to 1.
Default : 0
- debug_level
Debug level used when outputting the informations.
Default : 3
- print_hex
Additionally to the header informations, target_display will show the packet content in hexadecimal.
Default : no
- print_ascii
With this set to yes, a dump of printable characters found in the packet will be displayed.
Default : no
- conntrack
If this is enabled, the target will save connection tracking informations for each connection. With this, you'll see all the packets of each connection. Not only the packets in a single direction.
Default : no
Mode connection
In this mode, target_display will only show header information once for each new connection. It only has the parameter skip which behaves exactly like above.